_______________________________________________________________ maxim integrated products 1 for pricing, delivery, and ordering information, please contact maxim direct at 1-888-629-4642, or visit maxims website at www.maxim-ic.com. MAX16840 led driver with integrated mosfet for mr16 and other 12v ac input lamps 19-5671; rev 1; 2/11 general description the MAX16840 is an led driver ic for lighting applica - tions. it includes all the necessary features to design low-component-count led drivers for 12v ac and 24v ac input (e.g., mr16) light bulbs. a proprietary input- current control scheme allows led lamps based on this device to be compatible with electronic transformers, and dimmable with standard trailing-edge dimmers (where electronic transformers are present). the ic can be used in buck, boost, and buck-boost topologies and features. it has an integrated 0.2 i (max), 48v switching mosfet. the ic uses constant-frequency average current-mode control. it senses the input current through the voltage at the fb pin, and regulates its average. an input pin (refi) allows the setting of the input-current level. when the voltage at this pin is set below a certain threshold, the input current is proportional to this voltage, while when that voltage is beyond the threshold, the input current is set at a fixed, predefined level. this nonlinear behavior of refi allows its use to achieve thermal foldback, by connecting it to an ntc resistor. the ic also features an internal overvoltage protection on the in pin to protect the internal switching mosfet from damage if the led string is open or if the voltage on the led string is too high. the ic has a separate ext pin that can be used to guar - antee that there is a kick-start of current at turn-on for low-input voltages for proper operation with electronic transformers. ext drives an external npn transistor. once the uvlo threshold of 5.5v is crossed on in, ext is pulled to ground and the external npn transistor is turned off. the ic is available in a 3mm x 3mm, 10-pin tdfn power package, and is rated over the -40 n c to +125n c operat- ing temperature range. applications mr16 and other 12v ac or dc input led lighting applications features s control of the average input current to achieve operation with electronic transformers and dimmability s buck, boost, sepic, and buck-boost topologies s integrated 0.2 i (max) 48v switching mosfet s analog dimming and thermal foldback s output overvoltage protection s internal overtemperature protection s -40c to +125c operating temperature range s 3mm x 3mm, 10-pin tdfn package ordering information + denotes a lead(pb)-free/rohs-compliant package. * ep = exposed pad. typical operating circuit l1 bd1 c1 c4 r3 l2 d1 c2 led- led+ ext comp source in gnd drain 12v ac refi fb r1 r2 MAX16840 part temp range pin-package MAX16840atb+ -40n c to +125nc 10 tdfn-ep* abridged
|
